All About Hydraulic pump

Hydraulic pumps actually generate electricity which pumps hydraulic fluid and transfers it through the machine to perform pressing operations. When the pump is rated at 5000 psi, it can maintain fluid flow against a load of 5000 psi or use pressures as high as that. You can also get the best service of compression molding presses through various online sources.

Image Source: Google

The power density of hydraulic motors is ten times higher in volume compared to electric motors. The hydraulic pump is controlled by an electric motor or motor connected to a gear, belt or flexible coupling. This can be a gear pump, vane pump, axial piston pump or radial piston pump. The hydraulic pump is the "generator side" of the entire hydraulic press brake.

3. Drive mechanism – the power contained in the hydraulic fluid is fed to the drive mechanism which carries out the pressing process. There are different types of actuators, but the one used in a hydraulic press brake is a hydraulic cylinder.

Hydraulic cylinder consists of a cylinder cylinder and a piston piston. A large amount of energy contained in the hydraulic fluid is transferred to the piston to perform the linear work of pressing the sheet.

The stroke length of the piston can be programmed to vary depending on the thickness of the sheet and the angle of bending. The total stroke length of the piston depends on the cylinder length.

The force and pressure of the piston are precisely controlled and there is full pressure throughout the stroke. During printing, the speed can be programmed to vary or remain constant. The hydraulic cylinder is the "machine side" of the entire hydraulic press brake.